Skennet 95 mm too narrow for gs?
Posted: Fri Jan 18, 2008 5:43 pm
i´m running an 95mm skennet front & 106mmrts back (soon to be replaced with an 95mm airflow) for tight/hybrid on an axe 2.5 with 20-21"wb. now i want a gs board (so i dont have to change the hardware). so i have a couple of questions:
1.- 21"wb is too short for gs? should i go for a board with more wb; re-drill the board to have a 19"wb to use it for tight/hybrid.
or i´m ok with the 21" wb for gs, and go for anoter board with a smaller wb (like 18"-19")
2.- are 106mm rts/x trucks to narrow for gs? should i sell them and buy something a little wider (like bennett 5.0 or 129 rtx for front and spaced 110mm airflow back?.
thanks in advance
i have some time to make the right choice coz recently got a sprained knee = (
1.- 21"wb is too short for gs? should i go for a board with more wb; re-drill the board to have a 19"wb to use it for tight/hybrid.
or i´m ok with the 21" wb for gs, and go for anoter board with a smaller wb (like 18"-19")
2.- are 106mm rts/x trucks to narrow for gs? should i sell them and buy something a little wider (like bennett 5.0 or 129 rtx for front and spaced 110mm airflow back?.
thanks in advance
i have some time to make the right choice coz recently got a sprained knee = (