spherical in airflows

Airflow Skateboard Trucks

Moderators: Ramón Königshausen, Chris Hart

Post Reply
Bob Harper
Posts: 77
Joined: Thu Sep 08, 2005 11:18 pm

spherical in airflows

Post by Bob Harper » Wed May 04, 2011 8:12 pm

I'm toying with the idea of putting a sphyrical bearing in my Airflow.
I'm looking for any hint and tips.
Also has anyone ever mounted one in a RTX base plate and what was the out come.

David Graves-Witherell
Posts: 42
Joined: Mon Feb 22, 2010 9:35 pm
Location: Boston MA

Post by David Graves-Witherell » Thu May 05, 2011 12:03 am

My 110mm Airflow fits the tracker RTX baseplate. It came w/ an orion base place which only has new school spacing so I switched it out. Works fine. I also wonder about adding the spherical bearing.

Bob Harper
Posts: 77
Joined: Thu Sep 08, 2005 11:18 pm

Post by Bob Harper » Thu May 05, 2011 12:59 am

Thank David
I do have an RTX as my base plate. I was wondering if anyone has had success with
mounting a bearing in the pivot cup of an RTX base plate

Curt Chapman
Posts: 223
Joined: Fri Aug 04, 2006 6:23 pm
Location: UT, USA

Post by Curt Chapman » Sat May 07, 2011 6:10 am

I personally have not had the "you-know-what's" to start hacking on an Airflow to add a spherical to it. I'm ok with screwing up a $20 truck, not so OK with screwing up an Airflow..

One thing you can do is make a "fixed spherical" as some call it, or a "surf-key" as some others call it, or a small "plug" that fits between the bushings in the hanger. I use 99a or so bushings and lathe / trim them to fit: (Photos are not of an airflow, but you get the idea...) Not as precise as a spherical, but it is an improvement.
Image
Image

As far as the baseplate goes, if your pivot looks like this:
Image

You can fill in the allen head with epoxy or JB weld, chuck it up in a drill or a lathe if you have one and take a file / sand paper, whatever to it and make it look like this:
Image
Again, not as precise as a spherical, but an improvement over the stock pivot if yours is the allen-bolt.

I have put sphericals in baseplates similar to an RTX (Bennetts and Aces) so it is possible, you'd just have to rig the pivot bolt from the Aiflow to fit into it...
Image
Image

Bob Harper
Posts: 77
Joined: Thu Sep 08, 2005 11:18 pm

Post by Bob Harper » Sat May 07, 2011 6:19 pm

THANX CURT
I KNEW I'D GET AN ANSWER FROM MR. EXPEIRIMENTAL GUY.
THE BUSHING IDEA LOOKS INTRESTING
AND I FEEL THE SAME.
NO KAHUNAS TO DRILL AN AIRFLOW
AND I DID FIND A LOCAL SUPPLIER FOR SPHERICALS.
LETS PUT OUR HEADS TOGETHER AN SK8 NEXT WEEKEND

Post Reply