ISSA - International Slalom Skateboarding Association

Hi,

I recently purchased this deck:

the pavel freerider.
I find the wheelbase a bit short, and from what i can see through google translate (my german is a bit rusty) drilling new holes would allow me to have a better behaving slalom board.

What re-drilling do you recommend, should I drill using the back holes as front holes and only drill 2 new holes or will that be too far back (and too much on the tail of the board, I'm afraid I'm gonna have to use a huge amount of wedged pads).

any recommendations from the pavel folks ?

TIA

Hi Pierre

Ah this is my pic. Yes the WB is really short. It´s 17". If you need a cheap board for Tight Slalom the deck is really good. Just drill 2 new holes in the back of the board and you can go for it. This board doesn´t have a real Tail so no big wedging...I think this should work.

yes the pic is from concretewave.de, thanks for the info.
i will drill the 2 holes.

Heiko!

Post that pic I sent you to show them the Dagger Model workds well in a Bowl as well.