ISSA - International Slalom Skateboarding Association

Posted: **Sat Jul 12, 2003 7:59 pm**

Great idea! I hope he doesn´t regret it. It will be awful hard to snowboard that one.

Posted: **Sat Jul 12, 2003 6:04 pm**

It's only a matter of time until snowboard manufacturer Burton comes along. Here's an early (homemade) prototype, shaped out of a Burton board.

They guy in the picture commented: "Cutting it out of a Burton snowboard was cheaper than getting a regular slalom deck. It also allowed me to select the thickness in the front vs the rear of the board as snowboards are thicker under the bindings then further back."