Edge repair of Subsonic deck- part 2

Slalom Skateboard Decks forum

Moderator: Marion Karr

Post Reply
Paul Howard
Posts: 202
Joined: Sat Dec 27, 2003 7:15 pm
Location: Corvallis, Oregon. USA

Edge repair of Subsonic deck- part 2

Post by Paul Howard » Sun Jun 14, 2020 1:34 am

Here's the initial damage from a skogging mishap, and fixing it with JB Weld and 1/16" RC Aircraft plywood and fiberglass. Hope you like it.
Attachments
Board Repair 008 (2).JPG
Board Repair 008 (2).JPG (1.62 MiB) Viewed 5102 times
Board Repair 009 (2).JPG
Board Repair 009 (2).JPG (695.71 KiB) Viewed 5102 times
Board Repair 010 (2).JPG
Once this JB is cured rasp flat and sand it.
Board Repair 010 (2).JPG (1.31 MiB) Viewed 5102 times
Board Repair 013 (2).JPG
Use a rough wood rasp to rasp the JB Weld down flush with the deck, then fit your plywood to the area you want to repair.
Board Repair 013 (2).JPG (1.2 MiB) Viewed 5102 times
Board Repair 016 (2).JPG
Mix up more JB WELD Epoxy, place the plywood pieces where you want them, then clamp "Snug - NOT Tight"!!!
Board Repair 016 (2).JPG (1.06 MiB) Viewed 5102 times
Board Repair 017 (2).JPG
Board Repair 017 (2).JPG (1.25 MiB) Viewed 5102 times
Board Repair 018 (2).JPG
Again, Use the Heat-gun to make the JB Weld cure harder and cure WAY faster.
Board Repair 018 (2).JPG (1.35 MiB) Viewed 5102 times
Board Repair 019 (2).JPG
Board Repair 019 (2).JPG (1.2 MiB) Viewed 5102 times
Board Repair 021 (4).JPG
Board Repair 021 (4).JPG (359.15 KiB) Viewed 5102 times
Board Repair 022 (2).JPG
Cut and file to shape before fiberglassing.
Board Repair 022 (2).JPG (886.21 KiB) Viewed 5102 times
I just dig slalom!

Post Reply