Had one lying around, so I chopped it down to 'bout 111 mm:
Indy Low?
Moderator: Barret Deck
-
Curt Chapman
- Posts: 223
- Joined: Fri Aug 04, 2006 6:23 pm
- Location: UT, USA
Indy Low?
Anyone ever use an Indy "Low" for any slalom stuff?
Had one lying around, so I chopped it down to 'bout 111 mm:
Had one lying around, so I chopped it down to 'bout 111 mm:
-
Curt Chapman
- Posts: 223
- Joined: Fri Aug 04, 2006 6:23 pm
- Location: UT, USA
Your Indy Low looks cool
I played around with some Indy Lows when they FIRST came out. The low change made a lot of sense to me for a rear slalom truck.
I built the bushing seats up using JB weld for better bushing confinement--hoping to give better rear axle stability. That seemed to work out OK--I thought they were a pretty darn good rear truck. Looks like you are on to something.
I built the bushing seats up using JB weld for better bushing confinement--hoping to give better rear axle stability. That seemed to work out OK--I thought they were a pretty darn good rear truck. Looks like you are on to something.