Page 1 of 1

Posted: Sat Dec 07, 2002 10:26 am
by Glenn S
Chris,
If you don't mind I would like your ideas on a post about bearing spacers, wheel hubs, and bearings measurements that I posted in the Turner Wheel forum here:
viewtopic.php?topic=360&forum=52&0
, since it would also be applicable to Abec 11 slalom wheels as well.
Thanks, Glenn

PS. Adam T., if you read this. Would you please re-describe the "other trucks", "other boards", and "other wheels" to include "general discussion for each"? I would have posted the above mentioned post in such a folder because it is not applicable to just one brand. Thanks.

Chris, please check your private messages here.

<font size=-1>[ This Message was edited by: Glenn on 2002-12-07 05:20 ]</font>