Trackmate 6.8 software patch instructions
Posted: Thu Aug 14, 2008 10:06 am
Here are the instructions on how to update a Trackmate 6.x (only 6.3 or later) to 6.8.
(Contact me, Marcus, Donald or Corky to obtain the version 6.8 file)
(Contact me, Marcus, Donald or Corky to obtain the version 6.8 file)
/JaniStep 1
I've attached Megaload This is a program required to reprogram the Trackmate.
Install this program on your computer (it may require you to first install .NET from Microsoft).
Step 2
Run MegaLoad
You need to do three settings
1) Click on Open (File to program in flash) Select skate2007_68.hex
2) Select com port. You may need to use control panel to figure out what com port you have on your computer
3) Com port Speed Select 9600
Step 3
Connect com cable from PC to Trackmate.
Step 4
Make sure you have the com cable connected first.
Now power Timer Box, you should see something happening on Megaload program, it should flash the module and give a message.
It should list a bunch of messages in the message box, and say its successful.
Step 5
Now you're done.
Disconnect com cable
Test by power on and check version number scroll by, it should now be 6.8.