Tall Risers in Back

Bushings - Pivots - Speed Rings - Traction etc

Moderator: Henry Julier

Post Reply
Adrian Low
Posts: 3
Joined: Wed Jan 01, 2003 1:00 am
Location: Sydney, Australia
Contact:
Contact Adrian Low

Post by Adrian Low » Thu Jan 02, 2003 5:04 am

I was wondering why many of the swiss boards i have seen have the back truck jacked up pretty high with risers? What advantages does it have? Is it because of the nature of the high camber?
Top
Sam Gordon
Sam Gordon
Sam Gordon
Posts: 582
Joined: Wed Dec 11, 2002 1:00 am
Location: London UK
Contact:
Contact Sam Gordon

Post by Sam Gordon » Thu Jan 23, 2003 5:45 pm

The Swiss boards do have a cambered flex similar to the arched back of a hissing cat. With a comparatively soft flex to the American equivalent, there is greater inversion when the deck is down-weighted in pump and so approaches a 'bottoming out' situation. This greater flex and liveliness is in part due to the narrowness of the Swiss decks. The narrowness also leads to the feet overhanging the sides of the board so that on a rear-side turn, for example, your heels can touch the ground, throwing off your balance and leading to a world of pain. If the back of a Swiss board is lifted with risers, then you'll find that the front end is more so.
Top
Post Reply

Return to “Hardware & Bushings”